FluidsProcessing.nl UK
Subscribe to our monthly newsletter.
Your email address will never be disclosed to any third party.
Read our privacy notice.


News in brief
10-01-2019  |  1174x
Share this item

Champagne during New Year? What is actually happening now?

What happens if you pop a bottle of champagne with a bang?

We tried a CFD analysis using FloEFD to find out and came to surprising results. The temperature of the gas above the champagne is reduced by more than 100 C during uncorking and it comes out of the bottle with supersonic velocity (up to Mach 2.6).

During the uncorking, the gas between the champagne and the cork escaped. This CO2 gas is initially under pressure. This CO2 came into the bottle through the fermentation process, in which yeast converts the sugars into CO2 and ethanol. Unlike normal wine, champagne undergoes a second fermentation process in the bottle (the prise de mousse), so the CO2 stays in the bottle until the cork goes off and there is a considerable overpressure.

In the animation you can see the temperature development during the decorking process. It can clearly be seen here that it drops sharply when the gas leaves the bottle. More than 100 C below zero!

After these findings, we did a search on the internet and found an interesting article that substantiated this. The sharp fall in temperature is caused by the sharp drop in pressure (adiabatic expansion). The higher the starting temperature of the champagne, the lower the final temperature. At higher temperatures the CO2 even freezes (currently not modeled in our CFD analysis). In our simulation we assumed an initial temperature of 12 C. Nice to see that our results match the article results.

For those interested, here the titel of the article:
Unveiling CO2 heterogeneous freezing plumes during champagne cork popping

And what about the stress within the bottle, when the cork is still on it? At 12 C the CO2 supplies a pressure of 6 bar. We looked at it with FEA in Creo Simulate. The stresses at the pontil mark (the dent at the bottom of the bottle) are considerable. It is obvious that the pontil mark is needed and that its shape affects the stresses in that area.

Company information

Solids Processing Fluids Processing MB Maintenance SchuettgutPortal
Newsletter archive
Follow us
Service and contact
ContactDisclaimerPrivacyAdvertisingControl panel login